Fortigate routing table explained
- show ip route fortigate
- sh ip route fortigate
- show ip route bgp fortigate
- show ip route table fortigate
Show ip route fortigate cli...
Fortigate cli add static route
Technical Tip: How to Perform Routing Lookup from GUI and CLI
On v6.0.x, v6.2.,x or below: Go to Monitor -> Routing Monitor.
On v6.4.x and above Go to Dashboard -> Network -> Routing.
Related link:
Static & Dynamic Routing monitor
Why use the Routing Lookup in the Routing Widget instead of CLI:
The CLI version of this is this command ' '.
The output of this command will only show the routes taken by the FIB. It will not show whether the traffic will get routed through Policy Routes or not.
The advantage of using the Routing Lookup on the GUI is that if the route matches a Policy Route or SDWAN Rule, it will show that it gets matched.
Furthermore, it is possible to specify Source IP and/or Source Interface on the Routing Lookup Widget.
This is beneficial if we want to see how traffic from a specific VLAN, source IP etc is getting routed.
Local-Out Traffic aka Fortigate Self-Originating Traffic.
- After opening the widget, select
- sh ip route fortinet
- show ip route